CAB A8+ Manual do Operador descarregar pdf (Página 55)

55cab Produkttechnik GmbH & Co KG

Printhead position X

Using this setting will shift the entire print image to the left on the label. This

parameter should only be altered if you are printing the same format on several

printers, and the printed image is not consistent on each printer.

NOTICE !

The value of Printhead position X cannot be greater than the difference of

the printhead width and the defined label width in software. A value

greater than the difference will be ignored and the actual difference will

be used in place. For example, if the printhead width is 216 mm and the

label width defined in software is 212 mm, the printer will only accept a

value of 4mm or less for printhead position X. If Printhead position X is

set for 6mm, the printer will only shift the label 4mm.

The Printhead position X value to be changed will be flashing on the display.

It is possible to adjust the value for individual jobs using software. The front

panel values and software command values will be totaled together for printing.

Printhead position Y

Using this setting will shift the entire print image up or down the label. This

parameter should only be altered if you are printing the same format on several

printers, and the printed image is not consistent on each printer.

NOTICE !

Changing the Printhead position value Y also effects the peel position

and cut position as well. It will be necessary to readjust the values for the

peel and cut positions using the previous value +/- the printhead position

value.

The Printhead position Y value to be changed will be flashing on the display.

It is possible to adjust the value for individual jobs using software. The front

panel values and software command values will be totaled together for printing.

Tear-off position

When the "Tear-off mode" (see chapter "Print parameters") is active, an

additional feed forward will take place after completion of the print job. This

additional feed makes it possible to tear off the last label at the tear-off plate.

Using the setting "Tear-off position" the length of the additional feed can be

adjusted.

8. Printer Configuration

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Sem comentários

CAB A8+ Manual do Operador Página 55