CAB A6 Manual do Operador descarregar pdf (Página 114)

C-4 cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

Error message

File not found

FPGA

malfunction

Head

malfunction

Head open *

Head too hot *

Invalid data

Invalid outline

Invalid setup

LCD malfunction

Memory overflow

Solution

Check the contents of the card.

Switch printer off, then on again.

If error reoccurs, contact Service.

Switch printer off, then on again.

If error reoccurs, contact Service.

Lock the printhead.

After allowing the printhead to cool

down, the print job will continue

automatically.

If the fault occurs repeatedly reduce

the heat level or the print speed

setting in the software.

Cancel the current print job.

Re-check the data being sent.

Cancel the current print job.

Change to another font.

Reconfigure the printer's setup

(see chapter 8).

If error reoccurs, contact Service.

Switch printer off, then on again.

If error reoccurs, contact Service.

Cancel the current print job.

Reduce the amount of information on

the label format.

Possible cause

Requested file is not on the card.

Hardware error

Hardware error

Printhead is not locked.

Printhead has overheated due to

labels containing a lot of graphics,

text, bar codes, etc.

Error while downloading graphic

data.

Error with the selected font being

downloaded.

Setup is invalid.

Hardware error

Current print job contains too much

information (selected fonts, large

graphics)

Table C-3 Error Messages (continued)

Appendix C - Error Messages / Problem Solution

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 137 138

Comentários a estes Manuais

Sem comentários