CAB A6 Manual do Operador descarregar pdf (Página 127)

E-5cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

4. To lift the printhead assembly, swing the lever (2) clockwise until it stops.

5. Remove the printhead (3) from the pins (8) on the printhead carriage.

6. Carefully unplug the printhead (4) from the connectors of the printhead

cables (6 and 7).

7. Connect the new printhead to the cables.

8. Place the printhead into the assembly and insert the holes (5) onto the

pins (8).

9. Tighten the locking screws (1) by hand. Check that the printhead is

completely secured in the printhead carriage.

10. Swing the lever (2) again into the position shown in figure E-4.

11. Tighten the locking screws (1) completely. Do not over-tighten the locking

screws (1).

Fig. E-5 Changing Printhead A6 (II)

25 563 7 8

Appendix E - Replacing Assembly Units

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 137 138

Sem comentários

CAB A6 Manual do Operador Página 127