CAB A6 Manual do Operador descarregar pdf (Página 118)

C-8 cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

Cause and Solution

Printhead is dirty, clean the printhead (appendix D).

Printhead is defective (failure of heating elements), replace

the printhead.

Printer is being used with backfeed set to "smart" in cut or

dispense mode (see chapter 8). Set backfeed to "always" in

the Setup.

Printhead is dirty, clean the printhead (appendix D).

The printhead support is not adjusted for the width of the

media. Readjust the printhead support (see chapter 7).

Transfer ribbon is not secured to the ribbon supply hub.

Tighten the knob on the ribbon supply hub (see chapter 7).

Problem

Vertical white lines in the print

image

Horizontal white lines in the

print image

Print image is irregular or one

side is lighter than the other

side.

"Ribbon out" message appears

when ribbon is loaded

Table C-4 Problems / Solutions (continued)

Appendix C - Error Messages / Problem Solution

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 137 138

Sem comentários

CAB A6 Manual do Operador Página 118