CAB Apollo 1 Manual do Utilizador descarregar pdf (Página 13)

cab - Produkttechnik GmbHENG-12

Self Test

Power On System Test

When switched on, the Apollo automatically performs an internal system test.

If the test is completed successfully, the Apollo proceeds to the ONLINE mode, or

otherwise the printer switches to system mode FAULT - IRRECOVERABLE.

The top line of the display shows the version of the printer :

" **** APOLLO 1 **** ".

The bottom line of the display shows the numbers "123456" one after the other

depending on the progress of the several test steps.

Test Print

To prepare a test print, load media (labels or continuous paper) which extends over

the entire print width of the Apollo.

If you want to perform the test print in thermal transfer mode, also use transfer

ribbon of the maximum width.

During test print, the Apollo will not sense any label gaps. The length of the

printout will be about 9 in (230 mm).

To initiate a self test printout, press the key when switching on the printer

and keep it pressed down until the system test is completed.

The display shows "Test print", and the Apollo will print an internal test sample

which contains a variety of information about the configuration of the printer as well

as the results of the internal test.

The test printout can also include a range of hardware errors which have occurred

previously, even if they have disappeared again. This information is important for

service purposes and can only be deleted by Technical Support.

The information in the printout is also useful for checking the print quality, such as

differences in the blackness left/right, missing ink dots, etc. It is recommended you

carry out a print test immediately after receiving the printer.

After completing the test print, the Apollo will run the system test once again.

Then, the printer proceeds to ONLINE mode.

To cancel the test print press the key.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Sem comentários

CAB Apollo 1 Manual do Utilizador Página 13