CAB Apollo 1 Manual do Utilizador descarregar pdf (Página 24)

ENG-23cab - Produkttechnik GmbH

The Apollo is delivered with the tear-off plate (5) installed.

Before mounting the cutter, the tear-off plate has to be removed :

1. Switch the printer OFF.

2. Feed the label stock into the Apollo in such a way that the leading edge of the

first label is protruding slightly beyond the printhead (1).

3. Turn the printhead lever (2) counter-clockwise until it stops.

4. Remove the tear-off plate (5) from the guide holes (3).

5. Slide the cutter (4) into the guide holes (3) .

6. Turn the lever (2) clockwise until it stops.

7. Connect the cutter cable (6) to the 15 pin peripheral port on the front of the

Apollo.

8. Switch the printer ON. The cutter will perform a synchronized cutting cycle.

9. Press the key. The printer will feed one unprinted label forwards which

will be cut off by the cutter. The label stock feed is now synchronized for the

start of the printing process.

10. Activate the cutter function by selecting the cut mode in the software (in direct

programming use the "C" command).

Cutter Assembly

With the optional cutter assembly installed, labels or endless media may be cut

off immediately after being printed.

The cutter assembly is delivered in a separate package. Please keep the original

packaging in case the cutter must be returned !

The printer must be switched OFF before mounting the cutter !

The cutter may be used only when mounted onto the Apollo !

Installing and Operation

3 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

Sem comentários

CAB Apollo 1 Manual do Utilizador Página 24