CAB Apollo 1 Manual do Utilizador descarregar pdf (Página 4)

ENG-3cab - Produkttechnik GmbH

Connecting the Printer

Connection to Power Supply

The Apollo is designed for use with 230V A.C/ 50Hz (standard) or 115V A.C/60Hz.

Before connecting the printer to the power supply, make sure that the voltage

selected on the power supply module of the printer is the same as your main

power supply !

To change the voltage setting, open the cover (2) and remove the voltage selector

from the power unit.

If you have changed the operating voltage of your printer the fuses need

replacing as stated below !

Apollo 1/2 : 230V - 2 x T 4A 115V - 2 x T 6.3A

Apollo 3 : 230V - 2 x T 1.6A 115V - 2 x T 3.15A

When delivered, the correct fuses for the pre-selected operative voltage are

installed. You will find the necessary fuses for the other voltage in the accessories

package.

Slide the voltage selector back into the power supply module so that the correct

voltage is visible in the lid window (2).

Connect the printer to a grounded outlet using the power cable supplied in the

accessories package.

Connection to a Computer

Select the required interface settings using the Setup procedure and connect the

printer to the computer by a suitable interface cable.

Make sure that all connected computers and their connecting cables are

correctly grounded.

1 - Voltage selector

2 - Voltage selector

cover

3 - Power switch

4 - Power supply

connector

5 - Parallel interface port

6 - Serial interface port

Apollo 1/2 Apollo 3

1 2 3 4 5 6 7 8 9 ... 32 33

Sem comentários

CAB Apollo 1 Manual do Utilizador Página 4