CAB Apollo 1 Manual do Utilizador descarregar pdf (Página 27)

cab - Produkttechnik GmbHENG-26

Cut-/Peel-off Adapter

By using the cut/peel-off adapter it is possible, to operate the Apollo with cutter

assembly or present sensor in a special mode, where the print of one label can be

started by an external start signal.

In the peel-off mode, after removing a label from the peel-off position the use of the

adapter avoids the immediate print of the next label.

In the cut mode the print job can be divided in single prints.

In both cases, a label will only be printed, if it is required (cut/peel-off on demand).

1 - 15-pin SUB-D connector for cutter

assembly or present sensor

2 - 9-pin SUB-D connector for an external

release switch

3 - 15-pin SUB-D plug to connect the

adapter to the peripheral port of the

Apollo

Pin Assignment of the 9-pin SUB-D Connector

Pin 1/2 - Optocoupler inputs. A short impuls of 24V= at the pins (+ at pin 1, - at pin 2)

releases the print of one label (external start signal).

The start impuls has to be shorter than the print time of the label. The current is

internally limited to 10 mA.

with present sensor : the print is released only, if there is no label in the

presentation position

with cutter assembly : the printed label will be cut

Pin 3/4 - Transistor outputs of an optocoupler (pin 3 - collector, pin 4 - emitter). If the

adapter is used with the present sensor, the state of the transistor shows the

presence of a label in the peel-off position. If there is a label, the transistor is

blocked so that no current can flow between the pins.

At connecting the pins 3 and 4 the current has to be limited externally to

10mA. Otherwise the output will be destroyed.

1 2 3

Front side Back side

Pin 5 Pin 1

Pin 6Pin 9

Connectors

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Sem comentários

CAB Apollo 1 Manual do Utilizador Página 27