
Getting to Know and Using the Vehicle
Integrated devices
C/58
Mod. Apollo
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
BUTTONS
There are two integrated buttons on the panel:
- Button “1” (fig.201/C) temporarily prevents the acoustic signal (buzzer) of the anti-tipping system, anti-tipping system test.
- Button “2” (fig.201/C) changes the display.
Changing display visualisation
By pressing key ”2” (fig.201/C) display visualisation is changed cyclically following the logic below:
1. Timer and clock.
2. Speed and clock.
3. Hodograph and clock.
4. Timer and clock.
The normal visualisation of the display will be Clock and Hour counter. In the case of installation of the speedometer, the display
will automatically pass to the Clock and Speed display.
Clock regulation
To regulate the clock:
- Switch off the dashboard.
- Press key “2” (fig.201/C) and hold it down.
- Switch the dashboard on
- Hold key “2” down (fig.201/C) for 1.5 seconds for the duration of the “check”.
- Now you are in “Regulation” mode
With minutes characters flashing, press:
- key “1” (fig.201/C) to increase the character.
- key “2” (fig.201/C) to confirm the selection.
With hours characters flashing, press:
- key “1” (fig.201/C) to increase the character.
- key “2” (fig.201/C) to confirm the selection.
The calibration check has ended and the instrument starts to work normally (excluding the initial check).
1
2
(fig.201/C)
I CEL
L
2
A
P
Comentários a estes Manuais