CAB Apollo 1 Especificações Página 93
- Página / 234
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
C/21
- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
(fig.30/C)
P
0
1
2
IGNITION SWITCH
(fig.30/C)
The ignition switch, with the key, allows you to:
- Switch on the instruments.
- Switch on the diesel engine.
- Release the parking brake automatically with the diesel
engine in motion (fig.30/C Pos.”1”).
- Automatically engage the parking brake with the diesel
engine switched off (fig.30/C Pos.”0”).
Conditions for start-up
Start-up can only occur if:
- The operator is correctly seated in the driver’s seat.
- The gear selector is in the “N”, or neutral, position.
Switching on instruments
Turn the key to position “1” (fig.30/C) to power the electrical/
electronic instruments.
When the dashboard is switched on, a check will be carried
out on the instruments with all the indicator lights switched
on and emission of an acoustic signal.
These will remain on until the engine is switched on:
- Battery indicator light
- Engine oil pressure indicator light
Other indicator lights may remain lit depending on the
functions activated.
When the engine is running, the indicator lights signalling
faults/malfunctions should go off and only those referring to
active functions should remain switched on. If this is not the
case, consult the “maintenance” chapter of this manual and
contact a DIECI service centre.
Start-up
- Turn the key to position “1” (fig.30/C) to power the instru-
ments.
- Turn the key to position “2” (fig.30/C) and keep it there
for a few seconds in order to start-up.
- Once the engine has been started, release the key.
In the engine does not start within 5 seconds, try again at
regular 15 second intervals to avoid overloading the starter.
During the first few minutes of use, keep transfer and load
lifting speed low in order to heat up the engine and hydraulic
oil. Operate at low RPMs (max 1500), avoiding sharp ma-
noeuvres and accelerations until the temperature has risen.
- ATTENTION:
Bring the engine to a high number of RPMs before high tem-
perature and pressure can cause any serious damage to the
engine or the hydraulic system.
- ATTENTION:
With the motor started, the automatic parking brake disen-
gages. Before starting up the vehicle, always verify that the
parking brake has been manually engaged using its switch.
To release the parking brake when the engine is stopped,
refer to the paragraph, “towing the vehicle”.
- ATTENTION -
If the engine cannot be started, check that an emer-
gency button has not been pressed (fig.30/C Pos.”E”). If
pressed, contact the Safety Manager to make sure there is
no maintenance in progress, malfunctioning of the vehicle or
dangerous situations.
If the engine does not start, consult the “maintenance”
chapter of this manual and contact a DIECI service centre.
- MAINTENANCE MANUAL 1
- OPERATION AND 1
- Cod.: AXH1147/UK 3
- CHAPTER “A” 5
- CHAPTER “B” 5
- CHAPTER “C” 7
- CHAPTER “D” 7
- MAINTENANCE AND REGISTRATION 7
- Mod. Apollo 10
- GUARANTEE 11
- VEHICLE IDENTIFICATION 11
- INTRODUCTION 11
- FAC-SIMILE 19
- SAFETY REGULATIONS 21
- - DANGER 22
- - WARNING 22
- - PROHIBITION 22
- - NOTE 22
- GENERAL WARNINGS 23
- PREPARATION FOR EMERGENCIES 25
- DRIVER’S CAB 27
- STARTING UP THE VEHICLE 29
- ENVIRONMENTAL CONDITIONS 29
- - ATTENTION 31
- PARKING THE VEHICLE 35
- TEMPORARY HALT 35
- HOISTING THE MACHINE 37
- TRANSPORTING THE MACHINE 37
- CLEANING YOUR MACHINE 41
- FIRE PREVENTION 43
- TIGHTENING WHEEL NUTS 47
- STORING DANGEROUS FLUIDS 49
- CONTACT WITH DANGEROUS FLUIDS 49
- ROPS-FOPS CAB 59
- BAR 4,5BAR 4,5 69
- AXA 1506 71
- DEXTRON 2 71
- AXA 1492 71
- GETTING TO KNOW AND 73
- USING THE VEHICLE 73
- HAND SIGNALS 77
- External cab components 79
- Internal cab components 79
- INTERIOR CAB INSTRUMENTS 87
- I CELL 89
- MULTI-FUNCTION LEVER 95
- I CE 97
- SERVICE CONTROL LEVER 101
- - ATTENTION: 101
- Proportional services 103
- Alarm re-entry push button 105
- VEHICLE FUNCTIONS SELECTOR 107
- REVOLVING LIGHT SWITCH 113
- BOOM HEAD SOLENOID VALVE 115
- (OPTIONAL) 115
- FRONT HOOK 119
- AXA 1432 122
- USER INSTRUCTIONS AND 131
- GETTING TO KNOW THE VEHICLE 131
- INTEGRATED DEVICES 131
- “CENTRAL DASHBOARD” 131
- 891211 7 6 133
- I CEL 135
- (fig.207/C) 139
- (fig.208/C) 139
- ERRORS LIST 141
- Description What to do 145
- MAINTENANCE AND 147
- REGISTRATION 147
- MAINTENANCE PRESCRIPTIONS 149
- MANUFACTURER 151
- IDENTIFYING THE VEHICLE PARTS 153
- DO NOT USE 158
- SYNTHETIC-BASED OIL 158
- PARKING BRAKE 161
- Epicycloidal reduction gear 175
- (fig.57/D) 177
- (fig.69/D) 181
- 4.8 5.8 6.8 8.8 10.9 12.9 186
- 60° oval insert - BSP thread 188
- TROUBLESHOOTING 189
- TROUBLE SHOOTING 191
- MACHINE DETAILS 193
- AND MAINTENANCE WORK 195
- - ATTENTION 197
- ELECTRICAL DIAGRAMS 207
- AND CIRCUITS 207
- NAME DESCRIPTION SHEET 209
- WIRE COLOURS 213
- Valid certified 215
- HYDRAULIC CIRCUIT 223
- DIRECTIVE “ 225
- HYDRAULIC PLANT KEY 227
- TECHNICAL DATA 229
- TECHNICAL FEATURES 229
- Apollo 25.6 230
- (in seconds) 231
Manuais e produtos relacionados com Impressoras de rótulos CAB Apollo 1
Impressoras de rótulos CAB A8+ Manual do Operador
(120 páginas)
(120 páginas)
Impressoras de rótulos CAB A8+ Manual do Utilizador
(11 páginas)
(11 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais