CAB Apollo 1 Especificações descarregar pdf (Página 164)

Maintenance and Registering

D/18

Mod. Apollo

- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.

HYDROSTATIC OIL FILTER

(ﬁg.13/D pos.”1”)

Operate as follows to correctly replace:

1. Park the vehicle on a level surface.

2. Fully retract the boom and lower it.

3. Switch off the engine and remove the ignition key, hang up

a sign in the cab that reads “maintenance work under way”.

4. Place a container under the filter to collect any oil that

may come out during replacement.

5. Close the valve of the “supply tube ﬁlter” (ﬁg. 14/D Pos. “1”).

6. Remove the ﬁlter cartridge, unscrewing it using a ribbon

spanner (ﬁg.15/D).

7. Clean the ﬁlter support with a clean cloth which will not

leave felt, making sure the old sealing ring is removed.

8. Take the new DIECI-approved filter. Lubricate with the

same oil as used on the oil seal gasket.

9. Screw in the ﬁlter using only your hands, taking care to

set the lubricated oil gasket in its proper position.

10.

- ATTENTION: open the “supply tube ﬁlter” valve and

block it with a nylon clamp.

11. Switch on the vehicle and make sure there are no leaks.

- ATTENTION:

Waste oil is potentially harmful to the environment and must

be disposed of properly.

(ﬁg.13/D)

(ﬁg.15/D)

(ﬁg.14/D)

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 233 234

Sem comentários

CAB Apollo 1 Especificações Página 164