CAB Apollo 1 Especificações descarregar pdf (Página 170)

Maintenance and Registering

D/24

Mod. Apollo

- ATTENTION: - Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.

CAB VENTILATION FILTER REPLACEMENT

(ﬁg.40/D)

The cab ﬁlter should be replaced every 300 working hours.

Below you can find the sequence for proper replacement

operations:

1. Park the vehicle on a level surface.

2. Completely retract and lower the boom.

3. Switch off the engine and remove the ignition key, hang

up a sign saying “maintenance work under way”.

4. Remove the guard, in the rear of the cab (fig.40/D

Pos.”1”), by unscrewing the fastening screws.

5. Remove the worn ﬁlter and insert the new one (ﬁg.40/D

Pos.”2”).

6. Reassemble the guard

7. Restart the engine with the cab ventilation moving to

verify that the operation is correct.

- ATTENTION:

Do not clean the clogged ﬁlter with air or water and re-use.

At the end of its life, the filter loses determined features

which cannot be restored.

- ATTENTION:

In the event of vehicle use in particularly dust rich environments

(haylofts, etc.); the ﬁlter life is reduced by 100 hours.

- ATTENTION:

If the ventilation system malfunctions, check for ﬁlter clogging.

In the event that malfunctions persist even after filter re-

placement, contact a DIECI service centre.

- ATTENTION:

Do not use the vehicle without a cab ﬁlter.

Dust that enters the cab can cause health risks for the

operator and ventilation system malfunction.

(ﬁg.40/D)

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 233 234

Sem comentários

CAB Apollo 1 Especificações Página 170